Timer

Press the trip/fuel button until TIMER displays. This display can be used as a timer.

To start the timer, press the set/ reset button while TIMER is displayed. The display will show the amount of time that has passed since the timer was last reset, not including time the ignition is off.

Time will continue to be counted as long as the ignition is on, even if another display is being shown on the DIC. The timer will record up to 99 hours, 59 minutes, and 59 seconds (99:59:59) after which the display will return to zero.

To stop the timer, press the set/reset button briefly while TIMER is displayed.

To reset the timer to zero, press and hold the set/reset button while TIMER is displayed.

    See also:

    Vehicle Data Recording and Privacy
    This GM vehicle has a number of sophisticated computers that record information about the vehicle’s performance and how it is driven. For example, the vehicle uses computer modules to monitor and c ...

    Removing the Flat Tire and Installing the Spare Tire
    1. Do a safety check before proceeding. See If a Tire Goes Flat on page 10‑65 for more information. 2. For vehicles with a wheel cover or center cap, pull the cover or center cap away from ...

    Using Voice Commands During a Planned Route
    Cancel Route 1. Push . System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Yes. ...