Transferring a Call
Audio can be transferred between the Bluetooth system and the cell phone.
The cell phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the ignition is turned to ON/RUN.
See also:
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...
Three-Way Calling
Three-way calling must be supported on the cell phone and enabled by the wireless
service carrier.
1. While on a call, press .
2. Say “Three&-way call.”
3. Use the dial or call command to ...