How to Reset the Engine Oil Life System

Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change. To reset the system:

1. Turn the ignition to ON/RUN, with the engine off.
2. Press the DIC MENU button to display the Vehicle Information menu.
3. Press either the up or down arrows to view REMAINING OIL LIFE.
4. Press the SET/CLR button until 100% is displayed.
5. Turn the key to LOCK/OFF.

Or:

1. Turn the ignition to ON/RUN with the engine off.
2. Fully press and release the accelerator pedal three times within five seconds.

The system is reset when the CHANGE ENGINE OIL SOON message goes off.

If the CHANGE ENGINE OIL SOON message comes back on when the vehicle is started, the engine oil life system has not been reset. Repeat the procedure.

    See also:

    Fuses and Circuit Breakers
    If the vehicle is a hybrid, see the hybrid supplement for more information. The wiring circuits in the vehicle are protected from short circuits by a combination of fuses, circuit breakers and fusibl ...

    Traction Control System (TCS)
    The traction control system limits wheel spin. The system is on when the vehicle is started. ○ To turn off traction control, press and release located on the console. illuminates and the ...

    Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
    To replace one of these bulbs: 1. Open the tailgate. See Tailgate on page 2‑10 for more information. 2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull ...