Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Yes.” System responds: “OK, route canceled.”
3. Say “Goodbye.” Exits voice commands.
Route Preview
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Route Preview.” System responds with the next three maneuvers.
3. Say “Goodbye.” Exits voice commands.
Repeat
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Repeat.” System responds with the last direction given, then responds with
“OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Get My Destination
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Get my destination.” System responds with miles to the destination, then
responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
See also:
Anti-theft Alarm System Messages
THEFT ATTEMPTED
This message displays if the vehicle detects a tamper condition. ...
Tire Chains
WARNING Do not use tire chains. There is not enough clearance. Tire chains used
on a vehicle without the proper amount of clearance can cause damage to the brakes,
suspension or other vehicle part ...
Engine Heater
The engine coolant heater can provide easier starting and better fuel economy during engine warm-up in cold weather conditions at or below 0°F (−18°C). Vehicles with an engine coolant heater s ...