Using the “Digit Store” Command
If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system, say “Verify” at any time.
1. Press and hold for two seconds.
2. Say “Digit Store.” 3. Say each digit, one at a time, that you want to store. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Store,” and then follow the directions given by the system to save a name tag for this number.
See also:
Oil Pressure
This display shows the oil pressure in either kilopascals (kPa) or pounds per square inch (psi). ...
Towing the Vehicle
Notice: To avoid damage, the disabled vehicle should be towed with all four wheels
off the ground. Care must be taken with vehicles that have low ground clearance
and/or special equipment. Always ...
Cleaning the RSE Overhead Console
When cleaning the RSE overhead console surface, use only a clean cloth dampened with clean water. ...