Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
To replace one of these bulbs:
1. Open the tailgate. See Tailgate on page 2‑10 for more information.
2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull rearward until disengaging the two outer pins on the taillamp assembly from the vehicle.
A. Stoplamp/Taillamp/Turn Signal Lamp
B. Back-up Lamp
3. Turn the bulb socket counterclockwise to remove it from the taillamp assembly.
4. Pull the old bulb straight out from the socket.
5. Press a new bulb into the socket and turn the socket clockwise into the taillamp assembly.
6. Reinstall the taillamp assembly.
See also:
Hydraulic Power Steering (3.0L V6 Engine)
If power steering assist is lost due to a system malfunction, the vehicle can
be steered, but may require increased effort. ...
Leaving After Parking on a Hill
1. Apply and hold the brake pedal while you:
1.1. Start the engine.
1.2. Shift into a gear.
1.3. Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clea ...
Torque Lock
If you are parking on a hill and you do not shift your transmission into P (Park) properly, the weight of the vehicle may put too much force on the parking pawl in the transmission. You may find it di ...