Testing the Alarm

To test the alarm:

1. From inside the vehicle, lower the driver side window, and open the driver door.

2. Press 3. Get out of the vehicle, close the door, and wait for the security light to go out..

3. Get out of the vehicle, close the door, and wait for the security light to go out.

4. Reach in through the window, unlock the door with the manual door lock, and open the door.

This should set off the alarm.

If the alarm does not sound when it should, but the headlamps flash, check to see if the horn works.

The horn fuse may be blown.

To replace the fuse, see Fuses and Circuit Breakers on page 10‑31.

If the alarm does not sound or the headlamps do not flash, see your dealer for service.

    See also:

    Steering, Suspension, and Chassis Components
    Visually inspect front and rear suspension and steering system for damaged, loose, or missing parts or signs of wear. Inspect power steering lines and hoses for proper hook-up, binding, leaks, cra ...

    Battery
    The battery supplies power to start the engine and operate any additional electrical accessories. • To avoid break-down or failure to start the vehicle, maintain a battery with full cranking power. ...

    Protecting Exterior Bright Metal Parts
    Regularly clean bright metal parts with water or chrome polish on chrome or stainless steel trim, if necessary. For aluminum, never use auto or chrome polish, steam, or caustic soap to clean. A coati ...